Hayward SPX3015C Pump Impeller (Super II SP3000/SP3000X) – 1-1/2 HP Full Rated / 2 HP Max Rated
Hayward SPX3015C is a genuine replacement impeller for Hayward Super II pool pumps in the SP3000 and SP3000X families. This impeller is commonly referenced as 1.5 HP full-rated (often listed as 2.0 HP max-rated) and is used to restore proper flow and performance when the original impeller is worn, cracked, clogged, or damaged.
Key Features
- Part Number: SPX3015C
- Brand: Hayward
- Type: Pump impeller (Super II wet end)
- Common Rating Reference: 1-1/2 HP full rated / 2 HP max rated (application dependent)
- Designed for Hayward Super II SP3000 & SP3000X series pumps
- Helps restore circulation, pressure, and pump efficiency
Common Compatibility (Verify Your Exact Pump Model)
- Hayward Super II SP3000 Series
- Hayward Super II SP3000X Series
Common Signs You Need a New Impeller
- Reduced flow or weak return pressure (after confirming baskets and filter are clean)
- Pump noisy or vibrating due to impeller damage or imbalance
- Debris clogging inside the impeller eye
- Cracked or worn impeller vanes found during wet-end service
Installation Notes
- Disconnect power at the breaker before servicing.
- Match the impeller to your pump’s exact model/total horsepower (THP) configuration.
- Replace the pump shaft seal during impeller service to help prevent leaks into the motor.
- Inspect the diffuser and housing O-rings/gaskets while the pump is open and replace worn seals.
- Prime the pump after reassembly and check for leaks during startup.
Related Products
- Hayward SPX3015C
- Hayward Super II (SP3000) Pump Parts
- Hayward Super II Impellers
- Hayward Super II Shaft Seals
- Hayward Super II Diffusers
- Hayward Super II O-Rings & Gaskets
Maintenance Tips
- Keep skimmer and pump baskets clean to reduce debris reaching the impeller.
- Maintain proper water level to help prevent cavitation and premature impeller wear.
- Fix suction-side air leaks promptly to improve priming and reduce stress on the impeller.
- If flow drops suddenly, check the filter and baskets first, then inspect the impeller for blockage if needed.
